I-view CP-2160RD Deluxe Real Time Recording DVR Card Manual de usuario descargar pdf

CP-2160RD Deluxe DVR Board Hardware Manual (V1.4)

This section details the installation of your CP-2160RD Deluxe DVR board and how to make the necessary

connections. You may install up to 2 cards into a PC to reach 32 Video and 32 Audio input. The primary one is

referred as CP-2160RD Deluxe 0, the other one will be called CP-2160RD Deluxe 1. Before you start, please

make sure that your PC is off, and the power cable is unplugged.

The DVR system is called CP-2320RD Deluxe when combine the CP-2160RD Deluxe 0 and CP-2160RD

Deluxe 1 card onto a PC together.

The description of CP-2160RD Deluxe (as Fig 1) pins and sockets:

1: Video input –DB25 pin to connect the D-Sub BNC cable for video input.

2: TV out – S connector for single and split video output.

3: Video looping- Connect to a video looping board for video loop-out.

4 & 5: Transmit video signal – Link the S_TV_IN (5) socket of CP-2160RD Deluxe 1 into the S_TV_OUT (4)

socket of CP-2160RD Deluxe 0 DVR board to get 1-32 video signal output via a TV output port.

6: RESET- System failure socket, connect to the “ Reset “ socket of PC Motherboard. (CP-2160RD Deluxe 0)

7: EM_B – Panic button socket (CP-2160RD Deluxe 0 only)

8: LED – The indicator of auto reboots function. (CP-2160RD Deluxe 0 only)

9: 4 Pin power socket – The socket for power input from power supply of the PC. You must connect the power;

otherwise the CP-2160RD Deluxe DVR Bard cannot work properly.

10: Sensor connector-Connect to the sensor cable of the remote controller. (CP-2160RD Deluxe 0 only)

11: J11 – Connect the “Linking cable “between CP-2160RD Deluxe 0 and 1 to control 1-32 single and split

video out via a Remote Controller.

12: Audio in - Connect to an audio board for audio input.

13: J_USB – Connect to USB cable to the USB port of PC Motherboard.

14: PCI Express Bus – Plug PCI Express slot of Motherboard.

15: Jump – For DVR card number selection.

(Fig 1)

1 2 3 4

1CP-2160RD Deluxe DVR Board Hardware Manual (V1.4) This section details the installation of

2(A) System Failure Connections cable as shown in “Fig 2”: The DVR system will reboot and restore to the original status automatically whe

3(Fig 7) (Fig 8) DB-25 Pin (Fig 9) BNC Audio Connectors Fig 10 Controller. Please follow the process as below to achieve this function: a. Pleas

41. Completing Setup Complete setup by following three steps: 1. Run Witness XP program, login, and press the System configuration

Sin comentarios

I-view CP-2160RD Deluxe Real Time Recording DVR Card Manual de usuario